Notification

Icon
Error

New Topic Post Reply
zhangxiaosan
#1 Posted : Wednesday, September 13, 2017 7:25:47 AM(UTC)
Quote
zhangxiaosan

Rank: Advanced Member

Groups: Registered
Joined: 1/12/2016(UTC)
Posts: 1,284

<p>mm. 2, the door set after the three-dimensional horizontal, vertical tolerance tolerance of +2 mm, horizontal flatness tolerance allowed +1 mm; door sets and the combination of the wall should be fixed screws or gas nails (every meter a lot In 3); between the door and the wall gap with double-sided adhesive styrofoam, styrofoam should be coated evenly, dry after cutting smooth. Second, the line installation line installation should be uniform coating and door sets, wall </p>
<p>fixed, sets of line interface should be flat, tight, after installation side of the same line in a plane; due to wall is not flat, must ensure that line interface smooth. Sleeve tolerance allows tolerance of 1 mm. Third, the door installation 1, the door after the installation, should be flat, vertical, door and the door out of the flat face; door open no abnormal sound, flexible switch. 2, between the door and the gap between the door, the next seam is 6-8 mm, the remaining three </p>
<p>sides of 2.5 mm; all the allowable tolerance of +1 mm gap. 3, the door closed with a tight seal after the seal, do not swing. 4, hardware 1, door hinge should be vertical, flat; flat hinge should be in the door, the door corresponding to the slot, slot should be standardized, the same size and hinge, three allowable tolerance +0.5, after the formation of seamless , Hinge open should be flexible. The three-sided hinge is mounted in a mold and the plug should be inserted in </p>
<p>marine lumber plastic building material<br />
remove car wax from teak<br />
using composite decking for a basement floor</p>
Quick Reply Show Quick Reply
Users browsing this topic
Guest (5)
New Topic Post Reply
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.

Powered by YAF 1.9.6 RC1 | YAF © 2003-2017, Yet Another Forum.NET
This page was generated in 0.087 seconds.

Copyright © 2012 Loftygolf.com